Linux

10244 readers

436 users here now

A community for everything relating to the GNU/Linux operating system (except the memes!)

Also, check out:

Original icon base courtesy of lewing@isc.tamu.edu and The GIMP

founded 2 years ago

MODERATORS

Ategon@programming.dev

anzo@programming.dev

dwraf_of_ignorance@programming.dev

Unable to set 4k120Hz via Cable Matters DP->HDMI 2.1 converter (linux.community)

submitted 22 hours ago by mat@linux.community to c/linux@programming.dev

7 comments fedilink hide all child comments

I recently purchased a LG OLED C2 TV, which supports 4k120Hz but only has HDMI 2.1 ports. I am aware of HDMI 2.1 being an issue on AMD, even though my GPU is Nvidia (RTX 3060Ti) I want to switch to AMD in the future, so I opted to invest in an AMD-friendly setup. I purchased the Cable Matters active DisplayPort -> HDMI 2.1 converter mentioned in this Reddit thread, which purportedly can do 4k120. However, when I change it from the default 4k60 modeline to 4k120, the TV shows a "no signal" message. In fact, to get 120Hz I need to drop the resolution down to 1440p.

Even though I'm not going for VRR (yet), I also tried flashing the VRR-enabled "Spyder" firmware just in case it fixes the refresh rate (it does not). I tested every DP port on the 3060Ti as well, with no changes. What might I be doing wrong?

you are viewing a single comment's thread
view the rest of the comments

[–] toothbrush@lemmy.blahaj.zone 10 points 22 hours ago

In that reddit thread, they dont seem all too happy about that converter either, lots of people mention that it doesnt work correctly for them, so maybe your exact setup just isnt compatible with it?